Oil Piston Distributor

DX-Series

Key features

System overview: The system includes DX/DT series distributors and YET/YA series lubricators according to customer's needs.
- Lubricates at a steady flow rate in every cycle.
- Oil viscosity and lubrication time do not affect the flow rate.
- The system must cooperate with lubricators that include pressure release devices; a pressure switch is recommended.
- Recommended for lubrication applications with higher requirements.
DX-SERIES OPERATION:
01. The initial condition of the distributor before the pump starts is as shown in diagram 1.
02. Oil discharged from the pump pushes the mushroom valve upward.
03. As the mushroom valve plugs the center hole of the rod, pressure pushes the piston downward.
04. When the pump stops, pressure decreases and the piston recoils, causing lower-chamber pressure to push the mushroom valve back to plug the inlet hole; oil is pushed to the upper chamber through the rod hole, ready for discharge.
05. As the pump runs, steps 2-3 repeat, pushing the upper chamber to discharge.
06. When the pump stops, the distributor holds its position.

Special modes can be produced upon customer's request.
Model / No. of output bores / A / B (output volume options same for all	0.02/0.06/0.1/0.16/0.2/0.3/0.4/0.5 cc/stroke)
DX-0100	1 outlet, A=32, B=22
DX-0200	2 outlets, A=47, B=37
DX-0300	3 outlets, A=62, B=52
DX-0400	4 outlets, A=77, B=67
DX-0500	5 outlets, A=92, B=82
DX-0600	6 outlets, A=107, B=97
DX-0700	7 outlets, A=122, B=112
DX-0800	8 outlets, A=137, B=127
DX-0900	9 outlets, A=152, B=142
Individual bore output markings
DX-000-02	mark 2, output 0.02 cc/stroke
DX-000-06	mark 6, output 0.06 cc/stroke
DX-000-10	mark 10, output 0.1 cc/stroke
DX-000-16	mark 16, output 0.16 cc/stroke
DX-000-20	mark 20, output 0.2 cc/stroke
DX-000-30	mark 30, output 0.3 cc/stroke
DX-000-40	mark 40, output 0.4 cc/stroke
DX-000-50	mark 50, output 0.5 cc/stroke
Note	Because of continuous improvements, above specifications are subject to change without prior notice.